Maretron TLA100 Bedienungsanleitung PDF herunterladen (Seite 8)

J2K100 User’s Manual

Figure 3 – NMEA 2000

Connector Face Views

2.4.2 Connecting the J2K100 J1939 Interface

Vertical text on the J2K100 label identifies the J1939 connector. With the label right side up,

the J1939 connector can be found on the left side of the enclosure. In order to make the J1939

connection, you will need to locate the supplied female field attachable connector. This

connector is fitted to one end of a 3-conductor cable (not supplied). Make the connections

between the 3-conductor cable and the field attachable connector by following the instruction

contained within the bag. Although the field attachable connector has 5 terminals, you only

need to connect the CAN bus signals and ground signal (NET-H, white terminal; NET-L, blue

terminal; and ground (or NET-C), black terminal). The other end of the 3-conductor cable

needs to be tied into the J1939 network. You will need to identify the CAN bus signals on the

J1939 network by reviewing the manufacturer’s documentation. Most likely, they will identify

the CAN bus signals as CAN-H and CAN-L which correspond to the field attachable terminals

NET-H and NET-L respectively. You will also need to connect the NET-C or ground signal

found within the field attachable connector to the J1939 ground connection. See Figure 4 for

J1939 connector pin assignments

Page 4 Revision 1.2

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Keine Kommentare

Maretron TLA100 Bedienungsanleitung Seite 8