Maretron Alarm Module ALM100 Bedienungsanleitung PDF herunterladen (Seite 274)

time in this field, the alert will return to the “Active” state, and annunciators will

begin sounding again for that alert.

If a value of 0:00 is entered, then the alert will never re-trigger.

Offset Heading Set Point, Set Delay – If the direction being monitored differs

from the reference direction by more than the Offset Heading Set Point for longer

than the time specified in the Set Delay field, the alert will become active.

Offset Heading Clear Point, Clear Delay – If the alert is active and the direction

being monitored differs from the reference direction by less than the Offset

Heading Clear Point for longer than the time specified in the Clear Delay field,

the alert will become inactive.

Reference Direction – Enter the desired reference direction into this field. If the

monitored value differs from this value by more than the Offset Heading Set

Point, the alert will be triggered.

Get Current Heading – Pressing or clicking on this button will transfer the

current value of the direction being monitored into the Reference Direction Field.

10.3.6.4.13 Course Alert

A Course Alert is used to indicate that the course over ground (COG) has

changed from the reference direction more than a programmable amount. For

example, once a course has been established, an alert can be generated if the

course changes more than a specified amount. The reference direction can be

selected from the current direction (COG) or it can be manually entered.

The Course Alert is identical to the Direction Alert. In the editor, the word

Direction is replaced by Course.

10.3.6.4.14 Time Alert

N2KView can be configured with alerts that go active at a predetermined time,

such as an alarm clock. These alerts can also be configured to become active

periodically, making them useful for signaling watch changes (for example, every

four hours) or as a personnel alarm (making sure a crew member is at the helm

every 15 minutes).

When a Time Alert with a Repeat Interval of zero is accepted, it will be Disabled

to prevent further triggering.

When a Time Alert with a Repeat Interval greater than zero is accepted, it will

transition to the Inactive state, waiting for the next time it should trigger.

Revision 4.0.2 Page 274

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 379 380

Keine Kommentare

Maretron Alarm Module ALM100 Bedienungsanleitung Seite 274