Maretron Alarm Module ALM100 Bedienungsanleitung PDF herunterladen (Seite 77)

9.4.4.4 Pair Bluetooth Device (DSM800 only)

Pressing this button will cause N2KView to exit and start a separate program to

pair Bluetooth devices (mouse and keyboard) with the internal Bluetooth receiver

of the DSM800. When the program is complete, N2KView will restart. In some

cases the program can take a while (up to a minute) to start, so be patient.

9.4.4.5 Calibrate Touch Screen

The following Touch Screen Drivers have been pre-loaded onto the MB100 and

MBB200C.

• eGalax (USB)

These drivers have been tested on the NavPixel monitors

• Hampshire TSHARC (USB)

These drivers have been tested with the Hatteland HD Series monitors

• 3M Microtouch (USB & RS232)

These drivers have been tested with the Hatteland JH series monitors

These drivers have been tested with the Nauticomp Series II monitors

• ELO Intellitouch Drivers version 3.5.2 (USB)

• Penmount (RS232)

Touch Screen Drivers need to be calibrated to ensure that the position touches

are accurately reported to the software. Pressing this button will cause N2KView

to exit and start a separate program to calibrate the touch screen that you have

connected. When the program is complete, N2KView will restart. In some cases

the program can take a while (up to a minute) to start, so be patient.

Each driver has its own calibration program, and N2KView will examine the

connected screen and choose the appropriate calibration program.

Revision 4.0.2 Page 77

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 379 380

Keine Kommentare

Maretron Alarm Module ALM100 Bedienungsanleitung Seite 77