Maretron Alarm Module ALM100 Bedienungsanleitung PDF herunterladen (Seite 278)

100

101

Enable Computer Sound – This check box can be used to disable this

computer’s sound for this Alert. It does not disable the sounds generated by

remote N2KView stations or DSM250s in response to this Alert.

Tone – N2KView supports the presence of up to sixteen different annunciators

on the vessel. All annunciators must sound with the same tone, which is selected

from a drop-down list.

Figure 104 – Annunciator Tone Selection

Annunciators - For each alert, you may choose which annunciators sound the

selected tone. For example, you may wish the annunciator in the owner’s

stateroom to sound in the event of a general emergency or if smoke is detected,

but not if the engine coolant temperature is too high. If the annunciator has been

programmed with a label, N2KView will get the label from the annunciator and

append the label to the instance number. This makes it easier to know which

annunciator is being referenced.

10.3.7.2 Switch Actions Tab

The switch actions tab has been removed for safety reasons.

If the optional Control Module for N2KView has been licensed, it will be possible

to command breakers on the NMEA2000 bus to switch on or off in response to a

change of state of an alert.

The Switch Actions Tab for the Alert Actions Dialog is shown below.

Revision 4.0.2 Page 278

1 2 ... 273 274 275 276 277 278 279 280 281 282 283 ... 379 380

Kommentare zu diesen Handbüchern

Keine Kommentare

Maretron Alarm Module ALM100 Bedienungsanleitung Seite 278

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Maretron Alarm Module ALM100